 |
 |
 |
|
This repair and service manual covers Volvo Penta Stern Drives including 30GS 3.0L in-line 4-cylinder (135 HP), 43GL 4.3L V6 (160 HP), 43GI 4.3L V6 (180 HP), 43GXI 4.3L V6 (210 HP), 50GL 5.0L V8 (220 HP), 50GI 5.0L V8 (250 HP), 50GXI 5.0L V8 (270 HP), 57GS 5.7L V8 (225 HP), 57GS 5.7L V8 (250 HP), 57GSI 5.7L V8 (280 HP), 57GXI 5.7L V8 (320 HP), 81GI 8.1L V8 (375 HP), 81GXI 8.1L V8 (420 HP), DPX375 8.1L V8 (375 HP), and DPX420 8.1L V8 (420 HP), 2001 to 2004.
Clymer marine repair manuals can save you money on maintenance and repair bills. Step-by-step procedures and detailed illustrations guide you through every job, from routine maintenance and troubleshooting, to complete teardown & rebuild.
Table of Contents:
QUICK REFERENCE DATA
CHAPTER ONE | GENERAL INFORMATION
Manual organization | Warnings, cautions and notes | Safety | Model identification | Engine operation | Fasteners | Shop supplies | Galvanic corrosion | Propellers | Basic tools | Special tools | Precision measuring tools | Electrical component replacement | Electrical system fundamentals | Basic mechanical skills | Specifications.
CHAPTER TWO | TROUBLESHOOTING
Electrical component replacement | Preliminary inspection | Electric starting system | Charging system | Ignition system | Basic fuel system troubleshooting | Carburetor fuel system | Electronic fuel injection (EFI) system | Diagnostic trouble codes | Power steering system | Power trim electrical system troubleshooting | Power trim hydraulic system troubleshooting | Cooling system troubleshooting | Warning system | Engine troubleshooting | Drive system | Specifications.
CHAPTER THREE | LUBRICATION, MAINTENANCE AND TUNE-UP
Before each use | After each use | Lubrication | Fuel system maintenance | Engine coolant | Tune-up | Submersion | Specifications.
CHAPTER FOUR | LAY-UP, WINTERIZING AND FITTING OUT
Lay-up | Winterizing | Fitting out
CHAPTER FIVE | ADJUSTMENTS
Carburetor adjustment | Ignition timing adjustment | Shift cable and linkage adjustment | Throttle cable adjustment | Trim position sender and trim limit control module adjustment | Specifications.
CHAPTER SIX | ENGINE
Engine operation | Special tools | Replacement parts | Special service precautions | Engine removal/installation | Engine alignment | Rocker arm cover | Valve adjustment | Placing the No. 1 piston at TDC (firing position) | Lifter cover | Camshaft lobe lift measurement | Cylinder head | Rocker arm and pushrod | Flywheel housing | Drive coupler | Drive plate | Flywheel | Flywheel pilot bearing | Output drive shaft, seals and bearings | Oil pan | Oil pump | Harmonic balancer | Timing gear/chain cover | Timing chain and sprockets | Balance shaft | Camshaft and lifters | Piston and connecting rod | Rear main seal and rear main seal carrier | Crankshaft | Break-in procedure | Specifications.
CHAPTER SEVEN | FUEL SYSTEMS
Fuel system service | Mechanical fuel pump | Low-pressure electric fuel pump | Carburetor | Electronic fuel injection (EFI) | Intake manifold | Specifications.
CHAPTER EIGHT | COOLING AND EXHAUST SYSTEMS
Thermostat | Hose replacement | Recirculation pump replacement | Seawater pump | Oil and power steering fluid cooler replacement | Exhaust elbow | Exhaust bellow and flapper valve | Exhaust tube and flapper valve | Exhaust manifold | Specifications.
CHAPTER NINE | ELECTRICAL SYSTEM
Battery | Alternator | Starter motor and solenoid | Starter relay | Fuel pump relay | EFI system relay | Ignition system | Oil pressure sender | Oil pressure switch | Engine temperature sender | Engine temperature sensor | Engine overheat switch | Exhaust overheat switch | Intake air temperature sensor (IAT) | Throttle position sensor (TPS) | Idle air control motor (IAC) | Knock sensor | Knock sensor module | Engine control unit (ECU) | Warning horn replacement | Specifications.
CHAPTER TEN | DRIVE UNIT
Drive unit service precautions | Drive unit identification | Drive unit operation | Drive unit gear ratio | High altitude operation | Outdrive service precautions | Sacrificial anodes | Shifting and propeller rotation | Propeller | Drive unit removal and installation | Upper drive shaft housing | Universal joint | Shift housing service | Pressure and vacuum test | Specifications.
CHAPTER ELEVEN | INTERMEDIATE HOUSING AND TRANSOM SHIELD/BRACKET
Intermediate housing operation and inspection | Intermediate housing and suspension fork | Transom shield and mounting collar | Transom bracket (SX, DP-S and XDP models) | Transom bracket (DPX models) | Specifications.
CHAPTER TWELVE | POWER TRIM SYSTEM
Trim relay | Trim switch fuse | Trim limit control module | Trim motor | Trim pump | Fluid reservoir | Fluid screen | Hydraulic pump | Relief valve | Trim cylinder | Trim hose | Trim position sender | Filling and bleeding the trim system | Specifications.
CHAPTER THIRTEEN | STEERING SYSTEM
Safety precautions | Mechanical (manual) steering system | Power steering system | Specifications.
INDEX | WIRING DIAGRAMS
PRODUCT DETAILS:
- Publisher: Clymer Manuals 2004
- Author: Mark Rolling
- Binding: Paperback 8 x 10 inches
- Pages: 676 Hundreds of b&w photos and illustrations
- ISBN: 9780892878987
|
|
|
 |
|
 |
|
|
|
Related Products...
|
|
Personal Water Vehicle Service Manual 1st. Edition
|
|
|
|
|
|
|
Inboard/Outdrive Service Manual 6th Edition by Cly
|
|
|
|
|
|
|
Suzuki Outboard 2-140 HP Repair & Service Manual 1
|
|
|
|
|
|
|
Sea-Doo GSX, GT, GTI, GTX, HX, SP, SPI, SPX, XP, X
|
|
|
|
|
|
|
Inboard Engine, Transmission & Drive Service Manua
|
|
|
|
|
|
|
